GEAR-OIL PUMP 1400396 - Caterpillar

Illustration 1 g03748458Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the messages, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the message. Loose adhesive will allow the message to fall.Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any Cat dealer can provide new messages.Data Privacy (1)
This message is located under the front of the canopy for an open platform with two posts, on the left rear post for an open platform with four posts and on the right rear cab post for a closed platform.
Illustration 2 g01418953The Product Link System is a satellite communication device that transmits information regarding the machine back to Caterpillar and Cat dealers and customers. All logged events and diagnostic codes that are available to the Caterpillar Electronic Technician (ET) on the Cat data link can be sent to the satellite. Information can also be sent to the Product Link System. The information is used to improve Caterpillar products and Caterpillar services.Refer to Operation and Maintenance Manual, "Product Link" for more information.Support Point (2)
This message is located on both sides of the machine.
Illustration 3 g01866913This location is recommended for supporting the machine or jacking up the machine.Wait to Disconnect (3)
Illustration 4 g03408964Do not turn off the battery disconnect switch until the light has turned off. If the battery disconnect switch is turned off when the light is illuminated the DEF system will not purge and DEF could freeze and cause damage to the pump and the lines.Diesel Fuel Recommendations (4)
This message is located next to fuel fill.
Illustration 5 g02157153
Illustration 6 g02052934Use Ultralow Sulfur Diesel (ULSD) fuel.The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines certified to nonroad Tier 4 standards (Stage IV in Europe) and are equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability and will damage emissions control systems and/or shorten the service interval. Failures that result form the use of fuels are not Cat factory defects. Therefore the cost of repairs would not be covered by a Cat warranty.In Europe, ultra low sulfur diesel fuel will have a maximum of 0.0010 percent (10 ppm(mg/kg)) sulfur and is typically referred to as “sulfur-free”. This sulfur level is defined in European Standard "EN 590:2004".Refer to Special Publication, SEBU6250, "Caterpillar Machine Fluids Recommendations" for more information about diesel fuels and sulfur.Refer to Operation and Maintenance Manual, "Capacities (Refill)".