GEAR & CASE GP-TRANSFER 1864872 - Caterpillar

Illustration 12 g01370917
This machine is equipped with a Caterpillar Product Link communication device which should be deactivated in or near a blast site in compliance with applicable legal requirements. Failure to do so could cause interference with blasting operations resulting in serious injury or death.
Refer to Special Instruction, REHS1642, "Operation of the Product Link System" for additional information.Do Not Weld On The FOPS (11)Safety message (11) is positioned on the outside right of the cab.
Illustration 13 g01955345
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification plate.Rotating Shaft (12)This safety message (12) is located on top of the guard which is covering the drive shaft for the implement pump. The film is visible by removing the floorplate of the cab.
Illustration 14 g01460654
Rotatins shaft pinch hazard. The shaft under this cover is rotating anytime the engine is running. Contact with a rotating shaft could cause injury or death. Keep hands away.
Falling Hazard (13) (If Equipped)Safety message (13) is located on the rear of the Accugrade mast at eye level.
Illustration 15 g01108716
To prevent possible personal injury during installation and removal of the laser receivers, lower the mast to the minimum height and use an approved access system to reach the mounting locations of the laser receivers at the top of the mast. Do not climb on the blade.
Cleaning the Radiator (14)This safety message (14) is located on both sides of the radiator guard near the access slot.
Illustration 16 g01352487
Activating the machine's steering and work tools can be hazardous when personnel are working around the machine.Before moving the machine, make sure the machine is on firm level ground. Engage the parking brake. Make sure the area is clear of personnel before activating any work tool.Failure to follow this instruction could result in injury or death.
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in serious injury or death.
The engine must be shut off before any maintenance is performed. Use a wand in order to clean debris from the fan and baffle assembly.Do Not Weld On the ROPS (15)Safety Message (15) is positioned on the vertical support of the outside right ROPS post.
Illustration 17 g01955348
Structural damage, an overturn, modification, alteration, or improper repair, can impair this structure's protective capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate.