GEAR & BEARING GP-SWING 1912551 - Caterpillar

1912551 GEAR & BEARING GP-SWING Caterpillar parts 322C

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1912551
191-2551
1912551

Caterpillar 1912551 GEAR & BEARING GP-SWING

Buy GEAR & BEARING GP-SWING 1912551 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Polaris Slingshot HOSE, BRAKE CALIPER, LF, Genuine OEM Part 1912551, Qty 1

$174.99

21 Feb 2024
0.56[0.25] pounds
US: Fix_My_Toys

Polaris Slingshot HOSE, BRAKE CALIPER, LF, Genuine OEM Part 1912551, Qty 1
Polaris For schematic location 3 only || See product description below for vehicle fitment or to verify fitment for your specific vehicle, please contact us, and provide us with your VIN that can be found on your vehicle or your insurance card. || HOSE, BRAKE CALIPER, LF, Part 1912551, and all other Polaris Engineered service parts, deliver unmatched performance and fit for your vehicle. || Getting Polaris Engineered parts is a decision that pays off in the long run, because it ensures there is a long run.

Number on catalog scheme: 6

Caterpillar 1912551 Parts scheme GEAR & BEARING GP-SWING

For full view, you need register

Compatible equipment models: 1912551:

EXCAVATOR 322C Caterpillar

Information:

Installation Procedure
Check the condition of all the O-ring seals that are used in the hose assemblies and connected to the ripper control valve. If any of the O-ring seals are worn or damaged, replace the O-ring seals with new O-ring seals.
Illustration 1 g00536860
Illustration 2 g00536861
Fasten straps and a suitable lifting device to the ripper control valve. Put the ripper control valve in position in the machine. Install three washers and bolts (9) that hold the valve.
Illustration 3 g00536858
Be sure all hose assemblies for the ripper control valve are connected at their original locations on the valve.
Connect five hose assemblies (8) to the ripper control valve.
Illustration 4 g00536857
Connect three hose assemblies (7) to the ripper control valve.Note: One hose assembly is not shown.
Illustration 5 g00536855
Position hose assembly (6). Install bolts and washers (5) that hold the ripper control valve.
Illustration 6 g00536854
Connect hose assemblies (3) and (4) to the ripper control valve.
Illustration 7 g00536852
Connect four hydraulic hoses (2) to ripper control valve (1) .
Fill the hydraulic tank with oil to the correct level.Note: Refer to the Operation and Maintenance Manual for all fluid capacities and the proper filling procedures.