GEAR 1P1608 - Caterpillar

1P1608 GEAR Caterpillar parts D6C, D6D, D6D SR, D6E SR, D6F SR, D6G SR

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1P1608
1P-1608
1P1608

Weight: 12 pounds 5 kg.

Buy GEAR 1P1608 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

WVE by NTK 1P1608 Engine Cooling Fan Motor Relay Connector

$41.00

14 Mar 2024
0.13[0.06] pounds
Amazon.com

WVE by NTK 1P1608 Engine Cooling Fan Motor Relay Connector
WVE by NTK Pigtails provide electrical connection to various sensors and actuators || When not replaced, vehicle may experience intermittent or complete loss of electrical connection and/or oxidation of terminals || Designed to meet or exceed OE specifications in form, fit and function || Global coverage for import and/or domestic applications

$54.88

05 Feb 2024
0.13[0.06] pounds
Amazon.com

$43.37

24 Nov 2023
0.13[0.06] Pounds
Amazon.com

Show more prices Caterpillar parts

Number on catalog scheme: 8

For full view, you need register

Compatible equipment models: 1P1608:

TRACK-TYPE TRACTOR D6C D6D D6D SR D6E SR D6F SR D6G SR Caterpillar

Information:

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 8T-0914(1) Guide Pin 2
C - Guide Bolts
3/8 - 16 by 5 inch 2
D 1P-0808 Multipurpose Grease -
(1) Part of 9U-5105 Engine Tool Group
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01294394
Install Tooling (B) in the front of the crankshaft. Note: The dash marks on the sleeve in adapter (4) must be aligned with the dash mark on the crankshaft.
Attach a suitable lifting device to adapter (4). The weight of adapter (4) is approximately 70 kg (154 lb). Place adapter (4) in position on Tooling (B). Install bolts (3) that hold adapter (4) in place.
Remove Tooling (B). Note: The crankshaft front seal must be installed with the lip of the seal toward the inside of the engine. Ensure that the correct seal is installed on each end of the crankshaft.
Install Tooling (C) in the front housing.
Apply Tooling (D) to the O-ring seal on the outside diameter of adapter (1). Note: Ensure that all the parts are clean. Do not touch the lip of the seal. Do not use lubricant on the lip of the seal. Ensure that the arrow on the seal points in the same direction as the crankshaft rotation.
Place the crankshaft front seal and adapter (1) on Tooling (C). Carefully slide the crankshaft front seal and adapter (1) on the front housing.
Install bolts (2) that hold the crankshaft front seal and adapter (1) in place. End By:
Install the vibration dampers. Refer to Disassembly and Assembly, "Vibration Damper - Install".