GEAR ASSEM. (12 teeth) 1W1868 - Caterpillar

Illustration 1 g06000240
Table 1
Specification for 434-4255 Oil Pan Gp
Item Qty Part Specification Description
1 2 3P-0654 O-Ring Seal Before assembly, apply 1P-0808 Multipurpose Grease to the bores.
2 16 0L-1143 Bolt Use the following procedure to tighten the sequence for hand torque wrench or single spindle torque tool:
1. Tighten the end bolts followed by the left and right side bolts.
2. Start with a bold towards the center of the right and left side of the pan and work towards the ends.
3. Again tighten the three center bolts of the left and right side.
4. Again tighten all the end bolts.
3 2 7X-1547 O-Ring Seal Before assembly, apply 1P-0808 Multipurpose Grease to the bores.
4 2 0S-1590 Bolt In order to prevent stress on the tube assembly (6), use the following tightening procedure during assembly.
1. Tighten two blots (5) to 47 9 N m (35 7 lb ft).
2. Then tighten two bolts (4) to 47 9 N m (35 7 lb ft).
5 2 0S-1588 Bolt In order to prevent stress on the tube assembly (6), use the following tightening procedure during assembly.
1. Tighten two blots (5) to 47 9 N m (35 7 lb ft).
2. Then tighten two bolts (4) to 47 9 N m (35 7 lb ft).
7 2 4B-2363 Oil Drain Plug Torque to 145 15 N m (107 11 lb ft).
8 - - As required, applyLoctiteRTV Silicone Clear to the joints of the gasket.