GEAR GP-BEVEL & TRANSFER 2135173 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     2P-8250     Strap Wrench     1    
B     1U-6396     O-Ring Assembly Compound     1    Note: O-ring seals, gaskets, and seals should always be replaced. A used O-ring may not have the same sealing properties as a new O-ring seal. A reconditioning procedure should not be degraded because of a low cost component such as an O-ring seal or a gasket. Use Tooling (B) during the assembly procedure.Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision components of the pump or of the motor. All disassembly procedures and all assembly procedures must be performed on a clean work surface and in a clean hydraulic area. Keep cleaned parts covered and protected at all times.
Illustration 1 g00863940
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install bypass valve (5). Install spring (6). Install the O-ring seal and plug (7) .
Illustration 2 g00863930
Install O-ring seals (4) .
Illustration 3 g01218834
Position oil filter base (2) and install bolts (3) .
Use Tooling (A) in order to install engine oil filter (1). Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct installation procedure.
Close the access door on the right side of the machine.