GEAR - PLANET 2177389 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery or Battery Cable - Disconnect
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Initial 250 Service Hours
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 250 Service Hours
Aftercooler Core - Clean/Test
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Engine Crankcase Breather - Clean
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Every Year
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours
Coolant Extender (ELC) - Add
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Mounts - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Rotators - Inspect
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Every 4000 Service Hours
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust
Every 5000 Service Hours
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 8000 Service Hours
Fan Drive Bearing - Replace
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Every 605 670 L (160 000 US gal) of Fuel or 9000 Service Hours
Overhaul (Top End)
Every 662 450 L (175 000 US gal) of Fuel or 9000 Service Hours
Overhaul (Top End)