GEAR SET - 2 2216013 - Caterpillar

Install the Camera Group (If Equipped)
The following instructions are only required if the machine is equipped with a camera group
Table 3
Required Parts for the Camera Group (If Equipped)    
Item     Qty     Part Number     Description    
1     1     358-5961     Angle    
2     1     3V-4791     Grommet    
3     1     283-0659     Cable As    
4     3     8T-4191     Bolt    
5     5     8T-4121     Hard Washer    
6     1     132-5789     Clip    
7     18     7K-1181     Cable Strap    
8     2     8M-2772     Clip    
9     2     1B-3581     Clip    
10     3     104-6202     Clip    
11     2     8T-4137     Bolt    
Illustration 15 g03696652
(A) Camera assembly
Secure camera assembly (A) to the top of the rear guard assembly with the retained nuts.Note: Camera assembly (A) was removed in Step 2.a of the ""Removal Procedure"".
Illustration 16 g03682280
(1) 358-5961 Angle (2) 3V-4791 Grommet
Secure angle (1) to the side of the radiator group by using the retained hardware from Step 2.d of the ""Removal Procedure"".Reinstall all retained grommets, clips, and new grommet (2) .
Illustration 17 g03696749
(A) Camera assembly (3) 283-0659 Cable As (4) 8T-4191 Bolt (5) 8T-4121 Hard Washer (6) 132-5789 Clip (7) 7K-1181 Cable Strap (8) 8M-2772 Clip (9) 1B-3581 Clip (10) 104-6202 Clip
Connect one end of cable assembly (3) to camera assembly (A) .
Secure cable assembly (3) to the rear of the rear guard by using three bolts (4), three hard washers (5), clip (6), cable strap (7), and two clips (8) .
Secure cable assembly (3) to the right-hand support assembly by using two clips (9) and the existing bolts and washers.
Secure cable assembly (3) to the top of the counterweight assembly by using clip (10), cable strap (7), and the existing bolt and washer.
Secure cable assembly (3) to the links on the frame by using four cable straps (7) .
Illustration 18 g03696949
(1) 358-5961 Angle (2) 3V-4791 Grommet (3) 283-0659 Cable As (5) 8T-4121 Hard Washer (7) 7K-1181 Cable Strap (10) 104-6202 Clip (11) 8T-4137 Bolt
Route cable assembly (3) through grommet (2) on angle (1) .
Secure cable assembly to the side of the radiator group by using two bolts (11), two hard washers (5), two clips (10), and two cable straps (7) .Also secure the air conditioning lines group with the retained clips.
Illustration 19 g03696970
(3) 283-0659 Cable As (7) 7K-1181 Cable Strap
Connect cable assembly (3) to the rear of the cab assembly.
Secure cable assembly along the left-hand side of the frame, and between the hydraulic tank and cab by using eight cable straps (7) .