2266036 GEAR AS-IDLER Caterpillar parts
773F, 773G, 773G LRC, 773G OEM, 775F, 775G, 775G LRC, 775G OEM, 777C, 777D, 777F, 777G, 844H, 854K, 990H, 992K, 993K, AD55B, AD60, C32, D10N, D10R, D10T, D10T2, D11R, D11T
Rating:
Alternative (cross code) number:
CA2266036
226-6036
2266036
CA2266036
226-6036
2266036
Weight: 37 pounds 17 kg.
GENERATOR SET, WHEEL LOADER,
Compatible equipment models: 2266036:
Number on catalog scheme:
17
For full view, you need register
Information:
Which Generate This Code:MID 087 - Chassis ECMCID 1428 - Requested Gear Command SignalFMI 03 - Voltage Above NormalThis diagnostic code is recorded when the requested gear command signal circuit is shorted to ground. The circuit is a single wire that connects the Chassis ECM to the Drivetrain ECM. Wire (J882-BR) is connected to Chassis ECM contact J2-19 and Drivetrain ECM contact J2-24.Test Step 1. CHECK THE SIGNAL CIRCUIT FOR A SHORT TO GROUND
Turn off the keyswitch and the disconnect switch.
Disconnect the harness connectors from the Chassis ECM.
Disconnect the harness connectors from the Drivetrain ECM.
At the harness connectors for the Chassis ECM, measure the resistance from contact J2-19 (wire J882-BR) to all sources of ground. The sources of ground are contacts:
J1-13
J1-23
J1-56
J1-57
J1-70
J2-23
J2-63
All frame ground contactsExpected Result:Each resistance is greater than 5000 ohms.Results:
OK - Each resistance is greater than 5000 ohms. The ECM may have failed.Repair: Exit this procedure and perform this procedure again. Contact the technical communicator at your Cat® dealer. If the ECM requires replacement, see Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - A resistance is less than 5000 ohms. There is a short in the circuit with low resistance. Repair: Repair or replace the harness.STOP
Turn off the keyswitch and the disconnect switch.
Disconnect the harness connectors from the Chassis ECM.
Disconnect the harness connectors from the Drivetrain ECM.
At the harness connectors for the Chassis ECM, measure the resistance from contact J2-19 (wire J882-BR) to all sources of ground. The sources of ground are contacts:
J1-13
J1-23
J1-56
J1-57
J1-70
J2-23
J2-63
All frame ground contactsExpected Result:Each resistance is greater than 5000 ohms.Results:
OK - Each resistance is greater than 5000 ohms. The ECM may have failed.Repair: Exit this procedure and perform this procedure again. Contact the technical communicator at your Cat® dealer. If the ECM requires replacement, see Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - A resistance is less than 5000 ohms. There is a short in the circuit with low resistance. Repair: Repair or replace the harness.STOP
Cat SIS web machinery list:
Parts gear Caterpillar catalog:
24H, 24M, 773B, 773D, 773E, 773F, 775B, 775D, 775E, 775F
769C, 772B, 773B, 773D, 773E, 773F, 773G, 773G LRC, 773G OEM, 775B, 775D, 775E, 775F, 775G, 775G LRC, 775G OEM, AD55B, AD60
769C, 772B, 773B, 773D, 773E, 773F, 773G, 773G LRC, 773G OEM, 775B, 775D, 775E, 775F, 775G, 775G LRC, 775G OEM, AD55B, AD60
769C, 772B, 773B, 773D, 773E, 773F, 773G, 773G LRC, 773G OEM, 775B, 775D, 775E, 775F, 775G, 775G LRC, 775G OEM, AD55B, AD60
769C, 772B, 773B, 773D, 773E, 773F, 773G, 773G LRC, 773G OEM, 775B, 775D, 775E, 775F, 775G, 775G LRC, 775G OEM, AD55B, AD60
776D, 777D, 777F, 777G
D10N, D10R, D10T, D10T2
D10N, D10R, D10T, D10T2
D10N, D10R, D10T, D10T2
D10R, D10T, D10T2
D10R, D10T, D10T2
24H, 24M, D10R, D10T, D10T2
2223920
GEAR
C32, D10N, D10R, D10T, D10T2
C32, D10N, D10R, D10T, D10T2
3628082
GEAR-ACCESSORY DRIVE
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516B, 3516C, 776C, 789D, 793D, 797B
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516B, 3516C, 776C, 789D, 793D, 797B
3512, 924G, 924GZ, 924H, 924HZ, 928G, 928H, 928HZ, 930G, IT28G
2770588
GEAR-STARTING MOTOR RING
2384C, 2470C, 2484C, 2570C, 2670C, 320D GC, 320D L, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D2 L, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 525D, 535...
2384C, 2470C, 2484C, 2570C, 2670C, 320D GC, 320D L, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D2 L, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 525D, 535...
120M, 12M, 2470C, 320D GC, 320D L, 320D2, 320D2 GC, 320D2 L, 323D L, 323D2 L, 525D, 535D, 545D, 553C, 559, 613G, 924H, 924HZ, 924K, 928H, 928HZ, 930K, 938H, 938K, 950 GC, 953D, 963D, AP-600D, AP-655D,...
4346245
GEAR-CAMSHAFT
C140-16
C140-16
1552307
GEAR AS-IDLER
3508B, 3508C, 3516C, G3508, G3508B, G3512, G3512B, G3512E, G3516, G3516B, G3516C, G3516E, G3516H, G3520B, G3520C, G3520E, PMG3516
3508B, 3508C, 3516C, G3508, G3508B, G3512, G3512B, G3512E, G3516, G3516B, G3516C, G3516E, G3516H, G3520B, G3520C, G3520E, PMG3516
1510147
GEAR-ACCESSORY DRIVE
3508B, 3508C, 3516C, G3508, G3508B, G3512, G3512B, G3512E, G3516, G3516B, G3516C, G3516E, G3516H, G3520B, G3520C, G3520E, PMG3516
3508B, 3508C, 3516C, G3508, G3508B, G3512, G3512B, G3512E, G3516, G3516B, G3516C, G3516E, G3516H, G3520B, G3520C, G3520E, PMG3516
3918012
GEAR
C7.1
C7.1
3228408
GEAR
120M 2, 2384C, 2484C, 2570C, 2670C, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 525D, 535D, 545D, 555D, 559C, 563C, 573C, 579C, 924K, 930K, 938K, 95...
120M 2, 2384C, 2484C, 2570C, 2670C, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 525D, 535D, 545D, 555D, 559C, 563C, 573C, 579C, 924K, 930K, 938K, 95...
2285813
GEAR AS-CRANKSHAFT
773F, 773G, 773G LRC, 773G OEM, 775F, 775G, 775G LRC, 775G OEM, 777C, 777D, 777F, 777G, 844H, 854K, 990H, 992K, 993K, AD55B, AD60, C32, D10N, D10R, D10T, D10T2, D11R, D11T
773F, 773G, 773G LRC, 773G OEM, 775F, 775G, 775G LRC, 775G OEM, 777C, 777D, 777F, 777G, 844H, 854K, 990H, 992K, 993K, AD55B, AD60, C32, D10N, D10R, D10T, D10T2, D11R, D11T