GEAR-FLYWHEEL 2569651 - Caterpillar

Warning Signs and Labels
There may be several specific warning signs on your engine. Please familiarize yourself with all warning signs.Make sure that you can read all warning signs. Clean or replace warning signs if you cannot read the words or see the pictures. When cleaning the labels use a cloth, water and soap. Do not use solvents, gasoline, etc., to clean warning signs. The use of solvents, gasoline, etc., could loosen the sign's adhesive and cause the sign to fall off.You must replace a warning sign if it is damaged, missing or cannot be read. If a warning sign is attached to a part, and that part is replaced, make sure a new warning sign is installed on the replaced part. See your Caterpillar dealer for new warning signs.Do not operate or work on the engine unless you have read and understand the instructions and warnings in this Manual. Proper care is your responsibility. Failure to follow the instructions or heed the warnings could result in injury or death.Emergency Stop
Located on the outside of the control panel vandal door.
Always operate this unit with the vandal door open. Operating the unit with the vandal door closed restricts access to the emergency stop button and could result in injury or death.
Operation and Maintenance Manuals
Located on the outside of the control panel vandal door, above the emergency stop warning.
Do not operate or work on this engine or generator set unless you have read and understand the instructions and warnings in the operation and maintenance manuals. Failure to follow the warnings and instructions could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Batteries
Located near the batteries.
Improper jumper cable connections can cause an explosion resulting in personal injury.Batteries may be located in separate compartments. When using jumper cables, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal (if machine not equipped with starter negative terminal, connect to engine block.) Follow procedure in the operation manual.
Lifting
Located on the mounting base near the lifting holes.
Improper lift rigging can allow load to tumble causing injury and damage.1. Use adequate spreader bar as described because center of gravity is above base lift points.2. Attach four properly rated chains from base lift holes to spreader bar.3. Adjust chain lengths to position spreader bar over center symbol for level lift.4. Use single point center lift arch and 5N2171 Instruction Film when present.
General Hazard Information
Attach a DO NOT OPERATE or similar warning tag to the start switch or controls before performing maintenance or repairing the engine. These tags, SEHS7332, are available from your Caterpillar dealer. When appropriate, attach the tags at the engine and at each operator's position. Disconnect starting controls when appropriate. Do not allow unauthorized personnel on, around or in the engine unit when it is being serviced.Diesel engine exhaust contains products of combustion which may be harmful to your health. Always