GEAR AS-IDLER 2613445 - Caterpillar

Note: An additional 1.5 hours (total of 2.5 hours) will be allowed for an After Failure repair.
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 2*******
0-3000 hrs,
0-36 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
3001-6000 hrs,
37-72 mo 33.0% 50.0% 0.0% 0.0% 50.0% 50.0%
This is a 1.0-hour job for Group 2
Note: An additional 1.5 hours (total if 2.5 hours) will be allowed for an After Failure repair.
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Note: Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. Refer to the Operation and Maintenance Manual "Safety Section".
Refer to the Service Manual if/as necessary.
Note: For machines that are completed "After Failure", machine engine stopped with E617, complete rework Steps 1-9.
Note: For machines that are completed "Before Failure", complete only Steps 2-9.
1. Replace the 386-3463 Control Group. Refer to the Disassembly/Assembly. Refer to Image1.1.1.
Image1.1.1
2. Install the 515-3305 A3011 Software Group. Begin with connecting the ECM with CAT Electric Technician. Refer to Image1.2.1.
Image1.2.1
3. Select "File", then select "Disconnect". Refer to Image1.3.1.
Image1.3.1
4. Select "Utilities", then select "WinFlash". Refer to Image1.4.1.
Image1.4.1
5. Select "Folder icon" in Product Link, the select the file, open the file. Refer to Image1.5.1.
Image1.5.1
6. Select "Begin Flash". Refer to Image1.6.1.
Image1.6.1
7. Wait until the progress has completed. Refer to Image1.7.1.
Image1.7.1
8. After completion, select "Cat ET". Refer to Image1.8.1.
Image1.8.1
9. Confirm that the software group part number is in Product Link. Refer to Image1.9.1.
Image1.9.1