GEAR-INTERNAL 2679164 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     132-8223     110 Volt Power Pack     1    
1U-6221 Torque Wrench     1    
132-8143 36 mm Hex Link     1    
B     138-7574     Link Bracket     4    
C     -     Forcing Bolt
M24 x 3 by 5 inch     2    
D     5P-3931     Anti-Seize Compound     1    
E     1U-8846     Gasket Sealant     1    
Apply Tooling (D) on the locating pin and the pin bore in the main frame. Apply Tooling (E) on the mating surface of the main frame and the swing drive housing.
Illustration 1 g00875735
Attach Tooling (B) and a suitable lifting device to swing drive (2), as shown. The weight of swing drive (2) is approximately 510 kg (1125 lb). Install swing drive (2) into the original position. Be careful not to damage the pinion gear.Note: During installation, the locating pin for the swing drive can come out of the swing drive housing. The locating pin can be installed with a hammer after the swing drive is in place.
Illustration 2 g01206242
Use Tooling (A) to install bolts (1) that secure the swing drive to the main frame. Tighten bolts (1) to a torque of 900 100 N m (664 74 lb ft).
Fill the swing drive with oil. Refer to Operation and Maintenance Manual, "Swing Drive Oil - Change".End By: Install the swing motor. Refer to Disassembly and Assembly, "Swing Motor - Install".