GEAR-PLANETARY 2966184 - Caterpillar

Illustration 1 g03356623
Table 1
Specification for 117-0060 Oil Pan Gp
Item Qty Part Specification Description
1 - - As required, apply red Loctite 596 to the gasket joints before assembly.
2 10 1A-2029 Bolt Use the following procedure in order to tighten the bolts of the plate:
1. Tighten five bolts (3) to a standard torque.
2. Tighten bolt 1 through bolt 10 in a numerical sequence that is shown in Illustration 1 to a standard torque.
3 5 1A-2029 Bolt
4 2 6V-4315 O-Ring Seal Lubricate the bore of the O-ring seals lightly with the lubricant that is being sealed or an approved equivalent.
5 50 5P-5855 Bolt As required, apply blue Loctite 242 to the open top end of the bolt holes after assembly of the oil pan.
6 1 142-4159 Integral Seal As required, apply red Loctite 596 to the sealing surface of the integral seal before assembly.
7 2 3P-0654 O-Ring Seal Lubricate the bore of the O-ring seals lightly with the lubricant that is being sealed or an approved equivalent.
8 - - Before assembly, as required apply red Loctite 596 on the connecting joint of the front accessory drive housing and the front of the cylinder block.
9 4 5P-5700 O-Ring Seal Lubricate the bore of the O-ring seals lightly with the lubricant that is being sealed or an approved equivalent.
10 1 6I-0723 Oil Drain Plug Torque to 55 7 N m (41 5 lb ft).
Lubricate the bore lightly with the lubricant that is being sealed.
11 - - Before assembly, as required apply red Loctite 596 on the connecting joint of the flywheel housing and the rear of the cylinder block.
12 1 4B-2363 Oil Drain Plug Torque to 145 15 N m (107 11 lb ft).