GEAR CAMSHAFT DRIVE 2H2247 - Caterpillar

Monitoring System
The Electronic Control Module (ECM) monitors the operating parameters of the system being controlled. The ECM will generate an event code if a specific system parameter exceeds an acceptable range that is defined by the monitoring system. For information on the monitoring system, refer to Troubleshooting, "System Monitoring".Cross-Reference Information for Event Codes
Event codes are generated when abnormal operating conditions exist. Table 1 is a list of the event codes for the system. The event codes are cross-referenced with the appropriate procedure that can be used to troubleshoot the code.Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.
Table 1
Cross-Reference from "SPN-FMI Code" to Functional Test or Procedure
SPN-FMI Code Functional Test or Procedure
1761-1
Catalyst Tank Level