GEAR (54 teeth) 2P2905 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Loosen the fill/vent plug in order to relieve the hydraulic tank pressure. Tighten the fill/vent plug after the hydraulic tank pressure is relieved.
Illustration 1 g00290071
The hydraulic swing circuit filter is in the engine compartment on the right side of the machine.
Open the access cover on the right side of the machine.
Illustration 2 g00312370
Position a suitable container in order to contain the oil. Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
Remove the filter housing.
Remove the filter element. Discard the filter element.Note: Dispose of used filter elements according to local regulations.
Clean the filter housing. Inspect the O-ring seal of the filter housing. Replace the seal if the seal is worn or damaged.
Install a new filter element in the filter housing.
Install the filter housing.
Close the access cover on the right side of the machine.