GEAR (33 teeth) 2P7922 - Caterpillar

Illustration 1 g03591576This CID 2110 diagnostic code is associated with the inclination sensor. The FMI 02 diagnostic code means the Implement ECM has detected the data from the sensor is not reliable.The inclination sensor is mounted by a fixed mounting arrangement. When the sensor is mounted securely, no adjustment is necessary.The possible causes of this diagnostic code are listed below:
Sensor mounting is not secure
The sensor has failed.
Sensor vibration/shock limits have been exceededNote: Check for a secure mounting of the inclination sensor before proceeding to test steps. If the mount for the inclination sensor is secure and the CID2110 FMI 02 diagnostic code is active, continue troubleshooting the diagnostic code.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the CID 2110 FMI 02 diagnostic code is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure.Test Step 1. Cycle The Power To The System
Turn the key start switch to the OFF position. Wait for 15 seconds.
Turn the key start switch to the ON position.
Check the status of the CID 2110 FMI 02 diagnostic code. Expected Result:CID 2110 FMI 02 diagnostic code is no longer active.Results:
OK - CID 2110 FMI 02 diagnostic code is no longer active.Repair: Return the machine to normal service.STOP
NOT OK - CID 2110 FMI 02 diagnostic code is still active.Repair: Replace the inclination sensor.STOP