GEAR-INJECTION PUMP 3062164 - Caterpillar

Illustration 1 g03347207
Table 1
Specification for 291-4880 Front Housing Gp and 206-1211 Front Housing Gp
Item Qty Part Specification Description
During assembly, front and the rear faces of front plate, front face of block, and the rear face of housing assembly must be free of oil, fuel, water, dirt, and any other contaminants.
1 8 5P-4255 Locking Bolt Use the following procedure in order to tighten the bolts that fasten the plate to the cylinder block.
(1) Use hand tools to tighten the bolts.
Torque to 55 5 N m (41 4 lb ft).
(2) Use hand tools to tighten the bolts again.
Torque to 55 5 N m (41 4 lb ft).
2 - - Before assembly, apply ultra blue Loctite 587 in order to fill the space at the cylinder block, front plate, and oil pan joint.
3 - - Before assembly, apply ultra blue Loctite 587 to the bottom of the seal at the interface with the block. Apply sealant immediately prior to installation of the seal.
- - - After assembly, trim 166-9144 Gasket flush to face (4).