GEAR-BEVEL 3098763 - Caterpillar

Installation Procedure
Verify that all of the components are clean and free of foreign material prior to installation. Inspect all O-ring seals and the components for wear. Replace the O-ring and the components, if necessary.
Lubricate all O-ring seals with the lubricant that is being sealed.
Illustration 1 g00613794
Install plate (8) and the O-ring seal to diverter valve (2). Position diverter valve (2), as shown. Install four bolts (7) and the washers that hold manifold (6) to diverter valve (2) .
Install four bolts (9) and the washers that hold elbow (10) to diverter valve (2) .
Illustration 2 g00613792
Connect two hose assemblies (4) and (5) to diverter valve (2) .
Illustration 3 g00613791
Connect two hose assemblies (1) and (3) to diverter valve (2) .
Charge the air pressure in the air tanks. Refer to Operation and Maintenance Manual, "Starting with an External Power Supply" for the correct procedure.
Personal injury or death can result from air in the oil for the brake hydraulic system.Air in the system can prevent complete brake application and it is possible that the wheels on the machine can not be stopped.Air must not be in the oil for the brake hydraulic system to function properly.
Purge the air from the hydraulic oil in the brake hydraulic system. Refer to Air System and Brakes, Systems Operation, Testing and Adjusting, "Brake System Air - Purge".End By:
Remove the truck body retaining cable. Refer to Disassembly and Assembly, "Truck Body Retaining Cable - Remove and Install".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks (Front and Rear) - Remove and Install".