GEAR-CRANKSHAFT 3563225 - Caterpillar

(1) Torque for bearing cap to carrier stud: 824, 825 and 826 ... 330 35 lb. ft.(45,6 4,8 mkg)834 and 835 ... 400 40 lb. ft.(55,3 5,5 mkg)(2) Torque for the bearing cap nut: 824, 825 and 826 ... 615 115 lb. ft.(85,1 15,9 mkg)834 and 835 ... 825 125 lb. ft.(114,1 17,3 mkg)(3) Amount of free motion between the bevel gear and bevel pinion ... .014 .002 in.(0,36, 0,05 mm)(5) Primary torque for the bolts in the yoke to pinion shaft to find the amount of shims (4) needed ... 130 20 lb. ft.(18,0 2,8 mkg) Last torque for the bolts ... 200 20 lb. ft.(27,7 2,8 mkg)(6) Torque for case to case bolts (824, 825, 834 and 835) ... 280 20 lb. ft.(38,7 2,8 mkg)(826) ... 150 20 lb. ft.(20,7 2,8 mkg)Maximum permissible torque for turning the differential group one complete cycle (two revolutions in each direction) ... 25 lb. ft.(3,5 mkg)(7) Amount of end clearance of the thrust pin ... .002 .001 in.(0,05 0,03 mm)(8) Torque for the bolts in the carrier assembly to axle housing ... 350 35 lb. ft.(48,4 4,8 mkg)(9) Torque for bevel gear to case bolts: (824, 825 and 826) ... 210 15 lb. ft.(29,0 2,1 mkg)(834 and 835) ... 320 20 lb. ft.(44,3 2,8 mkg)