GEAR-WATER PUMP 3618234 - Caterpillar

Note: Inspect the O-ring seals. Replace the O-ring seals that are worn or damaged.Note: Lubricate the O-ring seals lightly with the lubricant that is being sealed.
Illustration 17 g01701453
Illustration 18 g01701456
Install turbocharger (24) and a new gasket. Apply Tooling (C) onto bolts (25). Install bolts (25).
Connect clamp (23). Tighten clamp (23) to a torque of 20 1 N m (177 9 lb in). Tap the clamp all around and tighten to a torque of 20 1 N m (177 9 lb in).
Illustration 19 g01701376
Install a new gasket and connect inlet elbow (22). Apply Tooling (C) onto bolts (21). Install bolts (21).
Illustration 20 g01701333
Position tube assembly (19) and install clamps (20).
Illustration 21 g01701317
Install a new gasket and connect tube assembly (19). Apply Tooling (C) onto bolts (18). Install bolts (18).
Illustration 22 g01701313
Connect tube assembly (17). Connect hose assembly (16). Install tube assembly (15).
Illustration 23 g01701293
Install hose (14).
Illustration 24 g01701277
Illustration 25 g01701274
Install U-bolt (13). Tighten clamp (12). Install U-bolt (11).
Illustration 26 g01701175
Install heat shield (10). Connect hose assembly (9).
Illustration 27 g01701155
Install O-ring seals (8).
Illustration 28 g01701096
Install elbow (7). Connect hose (6) and hose (5). Install bolts (4).
Illustration 29 g01701054
Use Tooling (A), Tooling (B), and a suitable lifting device in order to install platform (1). The weight of platform (1) is approximately 64 kg (140 lb).
Illustration 30 g01701033
Install bolts (3).
Illustration 31 g01701019
Install bolts (2).
Fill the engine coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change". End By:
Install the rear hood. Refer to Disassembly and Assembly, "Hood (Rear) - Remove and Install".