GEAR & BEARING GP-SWING 3778966 - Caterpillar

TARGET="_parent">Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Severe Service Application - Check
Daily
Cooling System Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belt - Inspect
Between 250 Service Hours and 1000 Service Hours
Electronic Unit Injector - Inspect/Adjust
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Cooling System Coolant (DEAC) - Change
Every 8000 Service Hours
Fan Drive Bearing - Replace
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
PM Level 1 - Every 12 750 L (3375 US gal) of Fuel or 250 Service Hours or 6 Months
Battery Electrolyte Level - Check
Belt - Inspect
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Electronics Grounding Stud - Inspect/Clean/Tighten
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Radiator - Clean
PM Level 2 - Every 102 000 L (27 000 US gal) of Fuel or 2000 Service Hours or 1 Year
Aftercooler Core - Clean/Test
PM Level 3 - Every 153 000 L (40 500 US gal) of Fuel or 3000 Service Hours or 2 Years
Belt Tensioner - Inspect
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Electronic Unit Injector - Inspect/Adjust
Engine - Clean
Engine Mounts - Inspect
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Every 256 000 L (67 500 US gal) of Fuel or 5000 Service Hours
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 380 000 L (100 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations