GEAR & BEARING GP 3779175 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-6396 O-Ring Assembly Compound 1
B 9S-3263 Thread Lock Compound 1 Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. All disassembly and all assembly procedures must be performed on a clean work surface and in a clean hydraulic area. Keep cleaned parts covered and protected at all times.Note: O-rings, gaskets, and seals should always be replaced. A used O-ring seal may not have the same sealing properties as a new O-ring seal. Use Tooling (A) during the assembly procedure.
Illustration 1 g00741704
Spool assembly (17) is installed in port (1) and port (3) in the pilot valve.
Spool assembly (18) is installed in port (2) and port (4) in the pilot valve.
Spring seat (7) is installed in port (1) and port (3) in the pilot valve.
Spring seat (10) is installed in port (2) and port (4) in the pilot valve.
Illustration 2 g00914124
Install bushing (16) in valve body (9).
Install new O-ring seal (21) on valve body (9).
Install spring pin (24) in plate (25). Note: Make sure that spring pin (24) is installed in the correct location in the valve body.
Install plate (25) on the pilot valve.
Install washers (27) and bolts (28). Tighten bolts (28) to a torque of 21 2 N m (16 1 lb ft).
Illustration 3 g00914179Note: Three different springs are available for the pilot valve. See Table 2.
Install spring (26) in the pilot valve.
Table 2
Spring
165-9461(1)
190-7750(2)
190-7751(3)
(1) Standard spring
(2) This spring reduces the operating torque by seventy percent.
(3) This spring reduces the operating torque by eighty percent.
Use the following procedure to assemble spool assemblies (17) and (18). Note: Spool (22) is assembled in Port (1) and Port (3) in the pilot valve. Spool (23) is assembled in Port (2) and Port (4) in the pilot valve.
Install washer (19) on the spool. Note: Spring (13) is installed on spool (22). Spring (15) is installed on spool (23).
Install spring (13) or spring (15) on the spool.
Put the end of the spool in the slotted opening of seat (11). Install seat (11). Note: Spool assembly (17) is installed in Port (1) and Port (3) in the pilot valve. Spool assembly (18) is installed in Port (2) and Port (4) in the pilot valve.
Install spool assembly (18) in the pilot valve.
Install new seal (1) in plug (2).
Install new O-ring seal (3) on plug (2).
Install rod (5) in plug (2). Note: Spring seat (7) is installed in Port (1) and Port (3) in the pilot valve. Spring seat (10) is installed in Port (2) and Port (4) in the pilot valve.
Install spring (6) and the correct spring seat in rod (5). Note: Make sure that spring seat (7) or (10) and the spring do not fall