GEAR & BEARING GP-SWING 3936549 - Caterpillar

End View
Side ViewRemove Gearshift Controls (Direct Drive & Special Application)
start by:a) remove seat and front support Gearshift controls can be removed with the transmission in the tractor. The transmission is removed for better illustration. 1. Remove three bolts (1) and washers from bearing. Remove the bearing and shaft. 2. Remove fifteen bolts (2) and washers from cover. 3. Fasten a hoist to the cover. Weight of the cover is 65 lb. (29.5 kg). Remove cover (3) and gasket. 4. Put four forks (4), (6), (7), and (8) in the positions shown. The forks can be moved by hand.5. Remove four bolts (5) and locks. Remove the forks.Install Gearshift Controls (Direct Drive & Special Application)
1. Put forks (2) in position in the transmission. Install the four locks and bolts (3).2. Fasten a hoist to the cover. Put cover (1) and gasket in position on the transmission. 3. Install fifteen bolts (4) and washers in the cover. Install shaft (5) and bearing. Install the three bolts and washers that hold the bearing in position.end by:a) install seat and front supportDisassemble Gearshift Controls (Direct Drive & Special Application)
start by:a) remove gearshift controls 1. Remove four nuts (2) from the housing. Remove housing (1). 2. Pull gate assembly (3) up and turn it 90°. Remove it from the cover. 3. Remove cover (4) and spring (5) from lever. 4. Remove the pin with a punch and hammer. Remove the pin from the gate assembly. Remove the lever from the gate assembly. 5. Remove ring (6) and boot (7) from cover. 6. Remove bolt (11) and nut (14) from lever (12). Remove the lever from the shaft. Remove washer (10) and bearing (9) from shaft. Remove cotter pin (8) and washer (13) from shaft. Remove the seal from bearing (9). 7. Loosen bolt (17). Use a soft hammer and hit lever (18) down until shaft (16) can be removed. Remove lever (15) from shaft. 8. Remove two bolts (19) and locks from retainer (20). Remove the retainer. 9. Remove four springs (22) and plungers (23) from the front bracket. Remove the front bracket.10. Remove two bolts (21) and locks from lock (25). Remove rear bracket (24). The four shafts and forks disassemble with the same procedures. 11. Remove wire (27). Remove bolt (26). Slide fork (28) off of shaft (29). Disassemble the other three forks and shafts.Assemble Gearshift Controls (Direct Drive & Special Application)
1. Assemble the four forks and shafts. Install the shaft in the fork. Tighten the bolt in the fork. Install a wire through the bolt and around the fork to prevent the bolt from becoming loose. 2. Install shafts (2), (3), (4), and (5) in front bracket (6).3. Put rear bracket (1) in position on the four shafts.4. Put the four shafts in the position shown in the front and rear brackets. 5. Install lock (8). Install the two locks and bolts (10) in the rear bracket.6. Install four plungers (9) and springs (7) in the front bracket. Install the