GEAR GP-FRONT 3968290 - Caterpillar

Assembly Procedure
Note: This section is only for changing the rotation of the pump. Parts at this level are nonserviceable.
Illustration 1 g00883128
Illustration 2 g00883127
Pump rotation is viewed from the shaft end. Cartridges are normally assembled for right hand rotation.
Reverse the rotation of a new cartridge. Rotate the following parts180 degrees.
Flex Plates
Cam Ring
Rotor
Vanes
Reverse the rotation of a new cartridge. Turn the following parts 180 degrees: flex plates, cam ring, rotor and vanes.
Illustration 3 g00877566
Illustration 4 g00885335
Note: In the V model pumps, the configuration of the flex plate is incorporated into the inlet support plate and into the outlet support plate. In VQ model pumps, the flex plates are separate components.
Install flex plate (7) to outlet plate (10). The bronze face of the flex plate must be facing toward the rotor.
Illustration 5 g00885334
Illustration 6 g00888319
Note: The vanes must be installed so that the leading edge is facing toward the direction of travel.
Install rotor (8) and vanes (9) to flex plate (7) .
Illustration 7 g00885333
Install ring (6) to flex plate (7) .
Illustration 8 g00885332
Install flex plate (5) to ring (6). The bronze face of the flex plate must be facing toward the rotor.
Illustration 9 g00885331
Install seal (4) to plate (3).
Install inlet plate (3) to cartridge (1). Install bolts (2) to inlet plate (3) .