GEAR (12 TEETH) 3H4842 - Caterpillar

Table 1
Fuel System Functional Test
$111D Fuel Rail High Pressure Decay Too High Refer to Troubleshooting, Fuel Flow is High. Refer to Test Step "Perform Fuel System Functional Test".
$111E Fuel Rail Low pressure Decay Too High
$111F Fuel Pump Flow Too Low
$1108 Excessive Engine RPM Change Do not allow engine RPM to fluctuate more than 100 RPM during test.
$108C Coolant Temp Low Coolant temperature must be great then 40° C (104° F).
$0002 Active Diagnostic Present Resolve any active diagnostic codes. Refer to the appropriate troubleshooting procedure.
$10CB Engine Load Too High Fuel rate is too high for the test. Reduce load applied to the engine during the test.
$10D0 Engine Has Not Been Running Long Enough Engine must be running during the test, start the engine before starting the test.
$0009 Service Test Aborted By ECM Check the service tool connection, do not abort the test before the test is complete. Repeat the test, if necessary.
$10A7 Coolant Temperature Too Low Allow the engine to warmup.
$10F5 Excessive Change in Engine Load There was a change in the engine load while the test was running. Make sure that the engine load is constant while performing the test.
$1213 Engine Oil Pressure Too Low The engine oil pressure is too low to perform the test. Refer to Troubleshooting, Oil Pressure Is Low.