GEAR (30 TEETH) 3K9924 - Caterpillar

Illustration 5 g03243962
Unlock latch (8), and open rear engine compartment door (9) on the left side of the machine.
Connect Tool (C) to Tool (B). Assemble both sets of tooling.
Install both sets of Tool (B) on Tool (A) .
Install Tool (J) in Tool (F). Install Tool (G) in Tool (F). Install Tool (H) on Tool (J).
Illustration 6 g03246438
Remove the plug from port "M5" (10) on the left side of the pump. Install one Tool (E) in port "M5" (10). Tighten Tool (E) to a torque of 12 Nm (9 lb ft).
Install Tool (H) on Tool (E) in port "M5" (10) .
Disconnect the machine harness from propel reverse solenoid (11) .
Connect one Tool (C) to Tool (G) in port "M5" (10) .
Illustration 7 g03246441
Remove the plug from port "M4" (12) on the right side of the pump. Install other Tool (E) in port "M4" (12). Tighten Tool (E) to a torque of 12 Nm (9 lb ft).
Connect second Tool (C) to Tool (E) in port "M4" (12) .
Disconnect the machine harness from propel forward solenoid (13) .
Illustration 8 g03246056
Connect Tool (M) and Tool (N) to Tool (L). Connect Tool (N) to diagnostic connector (14). Connect Tool (M) to USB port on Tool (K) .
Move engine start switch (4) to the START position. Release the switch when the engine starts.
Operate the engine at low idle for a few minutes. Depress throttle control switch (3) and hold the switch for approximately 2 seconds in order to operate the engine at high idle.Note: Two things indicate when the engine is at high idle. First, "High Idle" will appear on the display. Second, all three LED's next to throttle control switch (3) will be illuminated.
Monitor the hydraulic oil temperature with Tool (D). Operate the machine until the oil temperature reaches 43 5.6 °C (110 10 °F).
Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle.Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Move parking brake switch (2) in