GEAR GP-INPUT TRANSFER 3P8138 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 452-6016 Grease -
B 1P-0510 Driver Gp 1
Illustration 1 g06311753
Position shaft (8) and install roll pin (9).
Illustration 2 g06311786Note: Make sure that the bearings are seated fully against the shoulder of the pulley.
Apply 54 gram (1.90 oz) of Tooling (A) to bearings (5) and (7). Install bearing (7) and spacer (6). Use Tooling (A) to fill the area around spacer (6) half full. Install bearing (5). Use Tooling (B) to install lip seal (4).
Illustration 3 g01197345
Install pulley assembly (3), the washer, and bolt (2). Tighten bolt (2) to 55 10 N m (41 7 ft)
Illustration 4 g01197343
Fill cap (1) 50% with Tooling (A) and install.End By:
Install the belt tensioner. Disassembly and Assembly, "Belt Tensioner - Remove and Install".