GEAR 3T6207 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Engine Air Cleaner Element (Dual Element/Box Type) - Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Storage Procedure - Check
Fuel System - Prime
Fuel Tank Water and Sediment - Drain
Radiator - Clean
Daily
Air Tank Moisture and Sediment - Drain
Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Every 250 Service Hours
Belts - Inspect/Adjust/Replace
Engine Oil Sample - Obtain
Grounding Stud - Inspect/Clean/Tighten
Initial 500 Service Hours
Belts - Inspect/Replace
Compression Brake - Inspect/Adjust/Replace
Engine Valve Lash - Check
Valve Actuators - Check
Every 500 Service Hours
Battery Electrolyte Level - Check
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Hoses and Clamps - Inspect/Replace
Every 500 Service Hours or 3 Months
Belts - Inspect/Replace
Every 2000 Service Hours
Air Shutoff - Test
Fumes Disposal Filter Element - Replace
Every 2000 Service Hours or 1 Year
Coolant Sample (Level 2) - Obtain
Every 2500 Service Hours
Compression Brake - Inspect/Adjust/Replace
Engine Valve Lash - Check
Valve Actuators - Check
Every 3000 Service Hours or 3 Years
Coolant (DEAC) - Change
Every 4000 Service Hours
Air Compressor - Check
Engine Mounts - Inspect
Starting Motor - Inspect
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 760,000 L (200,770 US gal) of Fuel
Overhaul Considerations
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change