GEAR SET-BEVEL 4864949 - Caterpillar

The Electronic Control Module (ECM) detects a fault with the coolant temperature for the engine. The ECM detects the following faults:
The engine has been running for more than 185 seconds.
The trip point for the event code for the temperature of the engine coolant is reached.
Diagnostic code 0110-03 Engine Coolant Temperature voltage above normal is not active.
Diagnostic code 0110-04 Engine Coolant Temperature voltage below normal is not active.
Diagnostic code 0168-01 Electrical System voltage low is not active.
Table 1
Engine Coolant Trip Level Table
E361-1 E361-2 E361-3
Trip Point 113 °C (233 °F) 114 °C (237 °F) 118 °C (244 °F)
Delay to Activation 10 seconds 10 seconds 2 seconds
Reset Time 4 seconds 20 seconds 20 seconds System Response:The event code will be logged.The warning lamp on the control panel will be illuminated and a warning horn will sound.Possible Performance Effect:E361-1NoneE361-2The ECM will derate the power. The power will be derated at one percent per second. E361-3The ECM will derate the power. The power will be derated at one percent per second. The engine will not shut down in this application. Troubleshooting:Test Step 1. Refer to Troubleshooting, "Coolant Temperature Is Too High".Results:
OK - STOP