GEAR AS-PUMP 4957714 - Caterpillar

Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g01173114
Illustration 2 g01175355
Install the joints of bearings (8) at 30 degree angles from the centerline of the bores in body (9). Refer to Dimension (X) in Illustration 2. Install bearings (8) to a depth of 1.5 0.5 mm (0.059 0.020 inch). Refer to Dimension (Y) in Illustration 2.
Illustration 3 g01173113
Install body (7), gear assembly (6), and gear (5) .
Illustration 4 g01173112
Illustration 5 g01175360
Install the joints of bearings (4) at 30 degree angles from the centerline of the bores in cover (3). Refer to Dimension (X) in Illustration 5. Install bearings (4) to a depth of 1.5 0.5 mm (0.059 0.020 inch). Refer to Dimension (Y) in Illustration 5.
Illustration 6 g01173111
Install cover (3) and bolts (2) .
Illustration 7 g01173108
Install sensor assembly (1) .End By: Install the transmission oil pump. Refer to Disassembly and Assembly, "Transmission Oil Pump - Install".