GEAR (38 TEETH) 4K5048 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, and filters. The user is also responsible for the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components. Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Oil and Filter - Change
Engine Storage Procedure - Check
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check
Walk-Around Inspection
Every Week
Jacket Water Heater - Check
Every 250 Service Hours
Battery Electrolyte Level - Check
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Initial 500 Service Hours (or at first oil change)
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Air Shutoff - Test
Belts - Inspect/Adjust/Replace
Engine Oil and Filter - Change
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 2000 Service Hours or 1 Year
Alternator - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours or 3 Years
Aftercooler Core - Clean/Test
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Driven Equipment - Check
Electronic Unit Injector - Check/Replace
Engine - Clean
Engine Mounts - Inspect
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fan Drive Bearing - Lubricate
Every 380 000 L (100 000 US gal) of Fuel or 10 000 Service Hours
Overhaul Considerations
Overhaul
Fan Drive Bearing - Replace