GEAR 4W9983 - Caterpillar

Illustration 2 g03531063
Section A-A
Illustration 3 g03531064
View of C-C
Table 2
Item Qty Part Specification Description
13 6 307-2673 Plug As Torque to 36.75 1.75 N m (27.00 1.00 lb ft).
14 1 6V-7673 Bolt Apply a continuous bead of black Loctite RTV Silicone 598 to the case spotface, threads of the bolt (14) and the face of the hard washer (15). Remove excess sealant after the bolt (14) is torqued.
Tighten bolt (14) to 100 20 N m (74 15 lb ft).
15 1 5P-8245 Hard Washer
16 3 183-3409 Plug As Torque to 8 1 N m (71 9 lb in).
Illustration 4 g03531065
View of B-B
Table 3
Item Qty Part Specification Description
18 - - Apply a continuous bead of black Loctite RTV Silicone 598 to the area (18), the T-joint immediately before you assemble the torque converter housing (17). After assembly of the torque converter housing, remove excess sealant from the flange with a straight edge.
Illustration 5 g03531066
Table 4
Item Qty Part Specification Description
19 1 8T-4183 Bolt Tighten bolt to 100 20 N m (74 15 lb ft).
20 12 127-2170 Screw Torque to 28 7 N m (248 62 lb in).
Illustration 6 g03531067
Table 5
Item Qty Part Specification Description
- The washer end of pins used with springs (21) and springs (22) should be installed away from the clutch piston.
21 8 340-9914 Spring Length under test force is 32.21 mm (1.268 inch).
Test force is 125.0 20.0 N (28.0 4.5 lb).
Free length after test is 33.69 mm (1.326 inch).
22 4 340-9915 Spring Length under test force is 60.78 mm (2.393 inch).
Test force is 200 25 N (45 6 lb).
Free length after test is 62.87 mm (2.475 inch).