GEAR GP- 5362355 - Caterpillar

Illustration 1 g00523254
For instructions on reusability, refer to Guideline For Reusable Parts, SEBU8022, "Sealed And Lubricated Track".Maximum track press assembly force ... 780 kN (175352 lb) (1) Apply 4C-5592 Anti-Seize Compound to the threads and the washer face of each bolt that holds the half links together. Torque for bolts (1) that hold the half links together ... 870 90 N m (650 65 lb ft)Tighten the bolts by an additional 120° turn. (1) Apply SAE 30W oil to the bolt threads and the washer faces of each bolt before installation. Torque for bolts (2) that hold track shoes to links ... 870 90 N m (650 65 lb ft)Tighten the bolts by an additional 120° turn. (2) Apply SAE 30W oil to the bolt threads and the washer faces that hold the track shoes to links. (3) Minimum permissible grouser height for moderate utilization ... 84.0 1.5 mm (3.31 0.06 inch) Operations under average or heavy shock loads ... 38.0 mm (1.50 inch) (4) Height of an unused link ... 166.0 mm (6.54 inch)Height of 100 percent worn link Operations under little shock load or no shock load ... 153.8 mm (6.00 inch) (5) Distance from the center of one pin to the center of the next pin (pitch) ... 240.0 0.13 mm (9.449 0.005 inch)
Illustration 2 g00523705
(6) Distance from the face of the link to the end of the bushing ... 1.66 0.13 mm (0.065 0.005 inch) (7) Thickness of an unused thrust ring ... 11.10 0.08 mm (0.437 0.003 inch) (8) Bushings Diameter of an unused bushing ... 85.00 0.25 mm (3.346 0.010 inch)The minimum diameter of the bushing before the bushing is turned. Operations under little shock load or no shock load ... 74.80 mm (2.945 inch) Operations under average or heavy shock load ... 77.40 mm (3.047 inch) (9) Maximum permissible end clearance (end play) ... 0.20 mm (0.008 inch) (10) Extension of pin for each side of link ... 3.5 0.8 mm (0.138 0.031 inch)Track Adjustment
To prevent personal injury, never visually inspect the vent holes or the valves to see if grease or oil is coming out of them. Make sure the vent holes are clean before the tension is released on the track. Watch the front roller frame to see that it moves.
Illustration 3 g00553402
(1) Torque for fill and relief valves ... 34 7 N m (25 5 lb ft)Dimension (A) is the correctly adjusted sag in the track between the sprocket and the front idler. ... 130 10 mm (5.1 0.4 inch)Note: Adjust the track under the operating conditions that exists on the job site. Packing must NOT be removed from the track if packing conditions exist on the job site.
Move the machine forward for two times the length of the machine. Allow the machine to come to a stop without using the service brakes.
Put a tight cord over the grousers. Put the