GEAR-PLANETARY 5392444 - Caterpillar

ACTION REQUIRED
Refer to the attached Rework Procedure.
OWNER NOTIFICATION
Owners in the following countries will receive the attached Owner Notification:
US
Canada
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
EXAMPLE COPY OF OWNER NOTIFICATION
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR REWORKING THE STARTER MOTOR WIRING ON CERTAIN 3508B, 3508C, 3512B, 3512C, 3516B, 3516B HD, AND 3516C MARINE ENGINES
MODELS INVOLVED - 3508B, 3508C, 3512B, 3512C, 3516B, 3516B HD, 3516C
Dear Cat Product Owner:
The starter motor wiring needs to be reworked on certain 3508B, 3508C, 3512B, 3512C, 3516B, 3516B HD, and 3516C Marine Engines. The existing wiring engages only one of two engine starters. You will not be charged for the service performed.
Contact your local Cat dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
If you are no longer the owner of this product(s), please contact your local Cat dealer so that our records can be updated.
Please refer the dealer to their Service Letter dated 17Jun2013 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 17Jun2013 Service Letter
Rework Procedure
Ensure that all safety information, warnings, and instructions are read and understood before this service procedure is performed.
Terminal 4 on the SMMS2 and PPR1 is located behind, opposite of terminal 3 that is shown in Image 1.1.1.
Image1.1.1
Remove wire G229-P17 BK-18 that runs from ECM P-C1 pin _A to SMMS2 terminal 4. Refer to Image1.2.1.
Image1.2.1
Add wire D229-P60 BK-18 from PPR1 terminal 4 to SMMS2 terminal 4. Refer to Image1.3.1.
Note: Use 6V-2690 Heat Shrink after crimping the new terminals to prevent accidental shorting.
Image1.3.1