GEAR, SUN 63000391 - Caterpillar

Illustration 12 g06122353
Install the head (8) on housing (3). Install bolts (10).
Illustration 13 g00924791
Illustration 14 g00924792
Install Tooling (C) onto the pump housing. Use the dial indicator to determine the end play of shaft (36). Be sure that you move shaft (36) completely in both directions. Use appropriate tools to move shaft (36).
Subtract desired shaft bearing end play of 0.010 mm (0.0004 inch) to 0.100 mm (0.0039 inch) from the dial indicator reading. This is the thickness of shims (27).
Illustration 15 g06122353
Remove bolts (10), head (8), and the bearing.
Illustration 16 g00636169
Install pistons (28) into the original locations in spacer (30) and barrel (29). For best results, place the barrel in an upright position. Insert the pistons into spacer (30). Lift the pistons with spacer (30) and insert pistons (28) into barrel (29).
Illustration 17 g00636168
Position housing (3) horizontally. Install rotating group (26) and install shim kit (27) onto shaft (36).
Illustration 18 g00636214
Install shims (18) and install bearing (19) onto shaft (36).
Illustration 19 g00636167
Position two plates (22) and two locking plates (23) to the original positions on swashplate (21).
Apply Tooling (E) on bolts (24). Install bolts (24) to hold plates (23) and plates (22) to swashplate (21).
Illustration 20 g00636162
Install pin (16) in head (8).
Apply Tooling (E) to piston rods (11) and (14).
Install piston rod (11) and piston rod (14) in head (8).
Illustration 21 g00834356
Install spring (13), piston (12), and piston (15) onto head (8):
Illustration 22 g00834350
Use a light coat of Tooling (D) to hold plate (20) to head (8) during assembly.
Position head (8) onto housing (3) and bearing (19).
Illustration 23 g00842551
Install six bolts (10) to hold head (8) to housing (3).
Install plug (7) in head (8). Install the O-ring seal in head (8).
Illustration 24 g00636159
Install O-ring seal (6) to housing (3).
Illustration 25 g00834348
Install cover (5) and install bolts (4) to housing (3).
Illustration 26 g00834347
Install valve group (2) and install bolts (1) to the pump.End By:
Install the piston pump (hydraulic and steering). Refer to Disassembly and Assembly, "Piston Pump (Hydraulic and Steering) - Install" for the correct procedure.