GEAR (24 teeth) 6D6185 - Caterpillar

Illustration 5 g03729853
Illustration 6 g03729834Display button (23) - Press the Display button to adjust screen brightness, set Day/Night mode, Units, Language, and read Software License.Machine button (24) - Adjust machine settings and view parameters.Totals button (25) - View Lifetime and Trip Totals.Service button (26) - View Electronic Control Module (ECM) and Diagnostic Events, perform Configurations, Calibrations, and Service Tests.Payload button (27) - Press the Payload button and the Payload page will appear.Day/Night button (28) - Press the Day/Night button to toggle between Day and Night modes on the display.Scroll up/down buttons (29) - Press these buttons to scroll up and down through information that is shown on the display area.OK button (30) - After highlighting a selection with the scroll up/left button and with the scroll down/right button, use this button in order to confirm the selection.Back button (31) - Press the Back button to navigate to previous screen and cancels an action.Home menu button (32) - Use this button to return to the main menu.
Table 1
Basic Menu Structure Comments
MACHINE STATUS Sort By ECM Brake
Chassis
Engine
Transmission
VIMS
Aftertreatment
Sort By Type Configurations
Fluid Level Monitor (If Equipped)
HVAC
Lockout
Machine Status
Operator Inputs
Pressures
Speeds
Temperature
Tires (if Equipped)
PERFORMANCE SCREEN Brake Oil Temperature
Engine Speed
Ground Speed
Machine Slope
Body Up Status
DEF Level
Desired Engine Speed
Differential Oil Temperature
Engine Cool Temperature
Engine Oil Pressure
Engine Power Derate
Fuel Level To select and change a viewable parameter, press a Performance page area once.
The first four parameters in the list are the default parameters.
PAYLOAD Calibrated Payload Dumping
Loaded Stopped
Loading
Stopped Empty
Travel Empty
Travel Loaded
Uncalibrated Payload
TOTALS Lifetime Totals Distance Traveled
Load count
Loaded Travel Distance
Loaded Travel Hours
Payload Weight
Travel Time Lifetime Totals cannot be reset.
Trip Totals Travel time
Payload Weight
Distance Traveled
Load Count
SERVICE Diagnostics Events List The letter "X" will appear when the status of the event is currently active.
A dash "-" will appear when the status of the event is logged, but not active.
Event Details
ECM Summary Brake
Chassis
Transmission
Engine
VIMS
Aftertreatment
Display 2
Display 1
Service Mode Service Mode Enabled
Service Mode Disabled
Configurations Machine Maximum Engine Retarder Speed
Auto Lube Interval
Body Up Gear Limit
Service Lamp Mode
Road Analysis Control (RAC) Severity (If Equipped)
Transmission Overload Speed Limit
Machine Speed Limit
Maximum Forward Gear
Payload Payload Overload
Payload Target
Calibrations Truck Payload
Service Tests Auto Lube Manual Mode
DISPLAY SETUP Screen Brightness
Units Metric
English
Auto Night Mode
Software License Info Functional Test (Self Test)
If the action alarm does not sound during this test or machine monitoring displays are not functioning, do not operate the machine until the cause has been corrected. Machine operation with faulty action alarms or displays could result in injury or death as any Warning Category 3 notifications will not be relayed to the operator.
To ensure the proper operation of the monitoring system, check the system daily.The battery disconnect switch must be in the ON position.When you turn the engine start switch key from the OFF position to the ON position, the monitoring system will perform an automatic self-diagnostic test.The self-diagnostic test verifies that the outputs (gauges, indicators, and alarms) are operating correctly.When you turn the engine start switch key to the ON position, the following systems are tested for approximately one second: indicators, gauges and LCD displays.The gauges must go to the far right positions. All indicators must illuminate