GEAR 6E2510 - Caterpillar

8. Remove two sleeves (15) that connect oil manifold (14) to the filter group.9. Install 1/4"-20 NC forged eyebolts. Remove two dowel pins (16).10. Remove bolts (17). 11. Remove adapter (18). 12. Remove two sleeves (19).13. Remove oil manifold (14) as a unit.Install Hydraulic Control Valves
1. Install oil manifold (1). Install two dowel pins (4). Install bolts (5) and tighten to a torque of 35 3 lb.ft. (45 4 N m).2. Install the two sleeves (2) that connect the filter group to oil manifold. Check O-ring seals on sleeves. Make replacements if necessary.3. Install the two sleeves (3) that connect the adapter to the oil manifold. Check O-ring seals on sleeves. Make replacements if necessary. 4. Install filter group (7) and adapter (6). 5. Install plate (10). Install tube (8) in manifold. Check O-ring seal (9). Make a replacement if necessary. 6. Install pin (11). 7. Install selector valve (12). 8. Install cover (13). Install five bolts (14). 9. Install pressure control valve (15). 10. Install cover (16). Install bolts (17). Tighten the bolts to a torque of 22 3 lb.ft. (28 4 N m). 11. Install priority valve (18). Install six bolts (19). Tighten the bolts to a torque of 22 3 lb.ft. (28 4 N m).Disassemble And Assemble Transmission Hydraulic Control Valves
start by:a) remove hydraulic control valves1. Disassemble shift cylinder priority valve as follows: a) Remove bolts and washers (1). b) Remove valve spool (2) from valve body. c) Remove two bolts and washers (3). Remove plate (4).
There is a spring behind plate (4).
d) Remove valve spool (5) and spring (6) from valve body. e) Remove shims (7) from valve spool (5). f) Remove retaining ring (8) from valve spool. g) Remove ring (11), spring (10) and check valve (9). Retaining ring (8) was removed in Step f. h) Remove bolts and washers (12). i) Remove retainer (13) from valve body. j) Remove spacer (14).2. Assemble shift cylinder and priority valve as follows: Install spacer (14) in valve body. Install retainer (13) in valve body. Install bolts and washers (12). Tighten to a torque of 22 3 lb.ft. (28 4 N m). Install check (9), spring (10) and ring (11) in spool (5). Install retaining ring (8) in valve spool (5). Install original amount of shims (7) in spool (5). Install valve spool (5) in valve body. Install spring (6). Install plate (4) and two bolts and washers (3). Tighten to a torque of 22 3 lb.ft. (28 4 N m). Install valve spool (2) in valve body. Install bolts and washers (1). Tighten to a torque of 22 3 lb.ft. (28 4 N m). 3. Disassemble the pressure control valve as follows: a) Remove bolts (16) and cover (17) from pressure control valve body (15). b) Remove spring (24), load piston reset valve spool (23) and plug (22) from body (18). Remove load piston (26) and spacers. Remove stop (27), plunger (28) and