GEAR-COUNTERSHAFT 6Y0709 - Caterpillar

Procedure
Use the following procedure that is listed below to verify that the fittings on the fuel manifold group are tightened correctly before the engine is released back into service.C15
Illustration 1 g02116677
Typical example of a fuel manifold group for C15 engines (1) 353-8397 Connector As (2) 353-8398 Connector As (3) Fuel manifold group
Tighten connector (1) to a torque of 20 N m (14 lb ft). Refer to Illustration 1.
Tighten connector (2) to a torque of 18 N m (13 lb ft).
Illustration 2 g02116873
Typical example (4) Pilot fuel supply line (5) Main fuel supply line
Tighten the main fuel supply line (5) which connects to the main connector assembly to a torque of 26 N m (19 lb ft).
Tighten the pilot fuel supply line (4) which connects to the pilot connector assembly to a torque of 43 N m (32 lb ft).
Start the engine, and run the engine in order to ensure that there is no fuel leakage after service work is performed.C13
Illustration 3 g02117883
Typical Example of a fuel manifold group for C13 engines (1) 353-8397 Connector As (6) 353-9485 Elbow As
Tighten the elbow assembly (6) to a torque of 18 N m (13 lb ft). Refer to Illustration 3.
Tighten connector (1) to a torque of 20 N m (14 lb ft).
Illustration 4 g02116873
Typical example (4) Pilot fuel supply line (5) Main fuel supply line
Tighten the main fuel supply line (5) which connects to the main connector assembly to a torque of 26 N m (19 lb ft).
Tighten the pilot fuel supply line (4) which connects to the pilot connector assembly to a torque of 43 N m (32 lb ft).
Start the engine, and run the engine in order to ensure that there is no fuel leakage after service work is performed.