GEAR AS 6Y9763 - Caterpillar

Loading Data from a File
Connect the service tool to the ECM to be programmed.
Select "Copy Configuration" from the "Service" menu, and then select "Fleet/Key Configuration" from the submenu.If there is no recently loaded data available, the "No data is available..." message box displays.
Press "No" that you do not want to load data from the ECM. The "Fleet/Key Configuration screen" displays.
Press the "Load from File" push button. The "File Management" dialog box displays.
If the "Load from File" push button is pressed with unsaved data on the "Fleet/Key Configuration" screen, a message box displays. This message box asks if you want to save the changes.
Illustration 8 g03866163
Save-As Screen
From the"File Management" dialog box, highlight the file from the "Files" list box. Then highlight the "Fleet/Key Configuration document" that you want to load from the "Documents" list box.
Open the document. As the data loads, a progress bar displays. Then, the "Fleet Configuration" message box displays.
Press "OK". The "Fleet/Key Configuration" screen displays with the file data.Programming the ECM
Note: The data must be loaded from a file before you can program an ECM.Note: Keys that are already programmed into the ECM can be unchecked from the "Fleet/Key Configuration" screen. This unchecking of a programmed key is only a time saving measure. If you do not uncheck the keys, the "Program ECM" message box displays. This message box lists all keys that were not programmed because the keys were already stored.
Press the "Program ECM" push button. The "ECM Selector" dialog box displays.
Illustration 9 g01101974
ECM Screen
Highlight an ECM and press "OK" The "Please wait" message box displays. Then the "Testing ECM" progress bar displays.Note: You can cancel the uploading process at any time, by pressing the "Cancel" push button. The "Are you sure..." message box displays. Press "Yes" to cancel uploading the data or "No" not to cancel.Refer to the following procedures when you "Append" or "Replace" the key list. Refer to the "Append" section to append the list. Refer to the "Replace" section to replace the list.Append
Connect the service tool to the ECM to be programmed.
Start the Caterpillar Electronic Technician (ET)Note: This procedure requires Caterpillar Electronic Technician (ET) version 2004 SP1 or later.
Illustration 10 g03866178
Copy Configuration, Service Menu, Fleet/Key Configuration
Select "Copy Configuration" from the "Service" menu, and then select "Fleet/Key Configuration" from the submenu.
Open the document. As the data loads, a progress bar displays. Then, the "Fleet Configuration" message box displays.
Press "OK". The "Fleet/Key Configuration" screen displays with the file data.
Click on the "Program ECM" button. This button displays the Fleet key information box.
Illustration 11 g03866182
Append
Click on the "Append" button.
Illustration 12 g01097413
Click on the "Yes" button if you are prompted.When the data has been successfully uploaded, the "Programming complete." message box displays. Press "OK"Note: MSS can store a maximum number of 255 keys at one time. "Fleet/Key Configuration" determines the number of keys slots not programmed on the MSS. You cannot program more keys than the maximum number allowed. A message box displays informing you of the number of key slots available or that there are no more key slots