GEAR (34 Teeth) 7D6711 - Caterpillar

Illustration 1 g01093866
Lower the temperature of bearing cup (23).
Use Tooling (B) in order to install bearing cup (23).
Illustration 2 g01092483
Use Tooling (B) in order to install seal (21) into housing (22).
Use Tooling (C) in order to install retaining ring (20).
Illustration 3 g01092481
Illustration 4 g01092482
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install shim (18) and spring (19).
Use Tooling (B), Tooling (C), and a suitable press in order to install retaining ring (17) into barrel (16).
Illustration 5 g01092479
Install pins (15).
Illustration 6 g01092478
Install bearing (14).
Illustration 7 g01092476
Install pistons (12) into retainer (13).
Illustration 8 g01092475
Install pistons (12) and retainer (13) into the barrel.
Illustration 9 g01092474
Install swashplate (11).
Illustration 10 g01092472
Install shaft (9).
Raise the temperature of bearing cone (10).
Install bearing cone (10) onto shaft (9).
Illustration 11 g01092470
Install rotating group (8).
Illustration 12 g01092469
Install spacer (7).
Illustration 13 g01092468
Install bearing cone (6).
Illustration 14 g01092467
Lower the temperature of bearing cup (5).
Install bearing cup (5), O-ring seal (3), and port plate (4).
Illustration 15 g02511140
Install head (2) and bolts (1). End By:
Install the hydraulic fan motor (Fan Group).