GEAR-PLANETARY 7G2513 - Caterpillar

Engine: C13 (S/N: KCB1-UP; LEE1-UP) C15 (S/N: SDP1-UP; NXS1-UP)Introduction
Do not perform any procedure in this Special Instruction until you read this information and you understand this information. New Cat 270 Air Compressors are no longer available from the supplier. The Cat 270 air compressor can be replaced with a Bendix BA-921 air compressor.Important Safety Information
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Do not disconnect the air lines until the air pressure in the system is at zero. If hose is disconnected under pressure it can cause personal injury.
Parts Needed for C13 Engine
Table 1
Part Number     Description     Quantity     Where Used    
351-7089     Air Compressor Gp     1     Air Compressor    
223-3505     Seal     1     Air Compressor (Front Flange)    
5P-8245     Hard Washer     3     Air Compressor Mounting hardware    
6V-8197     Bolt     3     Air Compressor Mounting hardware    
302-7410     Hose     180 cm     Air supply    
8T-1117     Hose Clamp     2     Air supply    
5P-1230     Connector     1     Air supply Compressor end    
6V-5050     O-Ring Seal     2+1 (1)     Air supply Compressor end    
3E-4041 (1)     Elbow     1     Air supply (Elbow on turbo air intake elbow) Boosted app    
9S-8008 (1)     O-Ring Plug     1     Air supply (Plug intake manifold port) Boosted app    
379-8582     Tube As     1     Coolant return    
118-4728     Elbow     1     Coolant return (Compressor end)    
8M-0505     Connector     1     Coolant return (Thermostat Housing)    
319-8815     Hose     28 cm     Coolant supply    
9X-2488     Hose Clamp     3     Coolant supply (Use 3 for design A and 2 for design B    
6V-6609     O-Ring Seal     4     Coolant supply and return    
6V-1230     Elbow     1     Coolant supply 45 deg (compressor end) (F/UW design B)    
034-3679 (2)     Fitting     1     Coolant supply straight fitting (compressor end) (F/UW design A)    
295-1842     Adapter Kit     1     Governor adapter    
6N-8659     Hose As     1     Oil supply    
351-7088     Bracket     1     Rear support bracket    
6V-4248     Bolt     4     Rear support bracket mounting hardware    
6V-5839     Washer     4     Rear support bracket mounting hardware    
( 1 ) Additional parts needed for retrofit of