GEAR-PLANETARY 7G2516 - Caterpillar

Torque Converter Output Speed Sensor
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01633294
Remove bolts (1).
Lift the cover and remove the cover assembly (2) and the gasket. .
Illustration 2 g01633473
View of the sensor through the cover panel
Disconnect the harness assembly (3).
Remove speed sensor (4).
Install a new speed sensor.
Apply 8T-0065 Silicone Sealant to both mating surfaces of a new gasket. Place the gasket in the proper position.
Connect the harness assembly. Replace cover (2) in the proper position.
Install bolts (1). Transmission Output Speed Sensor
Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 3 g01634391
Disconnect harness assembly .
Remove the bolt and the washer.
Remove speed sensor (5).
Install a new speed sensor.
Install the bolt and the washer.
Connect harness assembly.