GEAR - PLANETARY (25 TEETH) 7Y0224 - Caterpillar

Caterpillar Products: AllIntroduction
This Special Instruction addresses the procedure for installation of the camera wash system for the WAVS Camera.Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. The safety information in this document and the safety information on the machine are not all inclusive. You must determine that the tools, procedures, work methods, and operating techniques are safe. You must determine that the operation, lubrication, maintenance, and repair procedures will not damage the machine. Also, you must determine that the operation, lubrication, maintenance, and repair procedures will not make the machine unsafe.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
Protect yourself and others; read and understand this warning. Fumes and gases can be dangerous to your health. Ultraviolet rays from the weld arc can injure eyes and burn skin. Electric shock can kill. Read and understand the manufacturer's instruction and your employer's safety practices. Keep your head out of the fumes. Use ventilation, exhaust at the arc, or both, to keep fumes and gases from your breathing zone and the general area. Wear correct eye, ear and body protection. Do not touch live electric parts.Refer to the American National Standard Z49.1, "Safety in Welding and Cutting" published by the American Welding Society, 2501 N.W. 7th Street, Miami, Florida 33125: OSHA Safety and Health Standards, 29 CFR 1910, available from U.S. Dept. of Labor, Washington D.C. 20210.
Note: Personal breathing protection should be worn by the personnel that are welding. Personal breathing protection will prevent fumes from entering the lungs of the person that is welding. Use a 1U-8088 Type H Respirator for breathing protection.Proper Welding Procedure on Machines and Engines with Electronic Controls
Proper precautions are necessary to prevent damage to electronic controls. When you weld on a machine with electronic controls, use the steps that follow:
Turn off the engine. Put the key start switch in the OFF position.
If the machine has a battery disconnect switch, open the switch. If the machine does not have a battery disconnect switch, disconnect the negative battery cable at the battery.
Connect the ground cable for the welder directly to the actual machine component that will be welded. Attach the clamp for the ground cable as close as possible to the area that is being welded. This will reduce the chance of damage from welding current to the components that follow: bearings, hydraulic components and electrical components.Note: Do not use electrical components as a ground point for the welder. Do Not use ground points for electronic components as a ground point for the welder.
Protect the wiring harnesses from the weld splatter.Required Parts
Illustration 1 g01341876
(1) Bottle Mounting Hardware (2) Check Valve (3) Nozzle Mounting Bracket (4) Bracket Mounting