GEAR GP-BEARING & 7Y1560 - Caterpillar

Table 2
Hydrostatic Transmission ECM Contact Description J2 (1)    
No. (2)    Function    Type    Active State    
1     Key Start Switch     Input     +Battery    
2     MSS LED Red     Output     On/Off    
3     MSS LED Green     Output     On/Off    
4     On/Off Return     Ground     Ground    
5     Air Inlet Heater     Output     On/Off    
6     Engine Shutdown Solenoid     Output     On/Off    
7     Starter Relay     Output     On/Off    
9     Monitor Panel LED 3     Output     On/Off    
10     Start Aid Relay     Output     On/Off    
11     Action Alarm     Output     On/Off    
12     Action Disarm     Output     On/Off    
13     Fault Lamp     Output     On/Off    
14     R Terminal     R Terminal     R Terminal    
19     Lift Pump Relay     Output     On/Off    
20     Max Speed Display     Output     PWM    
23     Service Brake Pedal Switch )Normally Closed)     Input     Ground    
24     Decel Pedal Sensor     Input     Freq    
25     Joystick Steering Sensor     Input     PWM    
26     Joystick Sensor "FNR"     Input     PWM    
27     Service Brake Pedal Sensor     Input     PWM    
28     Service Brake Pedal Switch )Normally Open)     Input     Ground    
40     Right Speed Sensor A     Input     Freq    
41     Right Speed Sensor B     Input     Freq    
42     Left Speed Sensor A     Input     Freq    
43     Left Speed Sensor B     Input     Freq    
55     Harness Code 0     Input     Ground    
58     Harness Code 1     Input     Ground    
59     Harness Code 2     Input     Ground    
60     Harness Code 3     Input     Ground    
64     CAN + (External)            
65     CAN - (External)            
67     CAN + (To Key Reader Module)            
68     CAN - (To Key Reader Module)     Output     On/Off    
( 1 ) The ECM responds to an active input only when all the necessary conditions are satisfied.
( 2 ) The connector contacts that are not listed are not used.