GEAR-SUN 8E4085 - Caterpillar

Removal Procedure
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact the skin.Be sure that the engine and components are cool enough to touch with your bare hand prior to performing any service work.
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Cap all lines, all hoses, and all tubes and plug all lines, all hoses, and all tubes. This will help to prevent fluid loss and will help to keep contaminants from entering the system.
Refer to Operation and Maintenance Manual, "Engine Oil - Change". Refer to Operation and Maintenance Manual, "Engine Oil - Check" for the correct draining and filling procedure.
Drain the coolant from the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Illustration 1 g06187324
Remove bolts (2) and panels (1).
Illustration 2 g06187852
Open door assemblies (3).
Illustration 3 g06187855
Illustration 4 g06187857
Disconnect hose assemblies (4) and (5).
Illustration 5 g06187860
Disconnect hose assemblies (7) and harness assembly (6).
Illustration 6 g06187861
Disconnect tube assemblies (8).
Illustration 7 g06187862
Disconnect tube assembly (9).
Illustration 8 g06187863
Attach a suitable lifting device to engine oil cooler (11). The weight of engine oil cooler (11) is approximately 40 kg (88 lb).
Remove bolts (10) and engine oil cooler (11).Installation Procedure
Install engine oil cooler (11) in the reverse order of removal.