GEAR-TRANSFER 8E7565 - Caterpillar

Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-9352 Engine Stand 1
8T-2826 Head Adapter 1
B 8T-3108 Compression Plate 1
8T-3109 Retaining Plate 1
5P-5247 Hydraulic Puller 1
1D-4720 Nut 2
C 8T-3035 Hydraulic Line 1
8T-0820 Hydraulic Pressure Gauge 1
3S-6224 Electric Hydraulic Pump
(115 Volt 50/50 Hz) 1
8S-8033 Electric Hydraulic Pump
(230 Volt 50/60 Hz) 1
9U-6600 Hand Hydraulic Pump 1
D 8T-2660 Valve Spring Compressor 1
515-1161 Valve Spring Compressor(1) -
8F-6350 Bolt 1
9S-8752 Nut 1
E 6V-7047 Hydraulic Puller 1
130-1449 Valve Seat Puller 1
9U-5098 Threaded Insert 1
F 8T-2676 Valve Guide Driver 1
G 8T-2781 Valve Guide Support Pedestal 1
4C-9839 Puller Rod Retainer Tool 1
1F-7958 Full Nut 1
7Y-2292 Washer 1
4C-8731 Dowel Puller Rod 1
5P-5247 Hydraulic Puller 1
(1) This tool is an alternative Valve Spring CompressorStart By:
Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
Remove the gas admission valve. Refer to Disassembly and Assembly, "Gas Admission Valve - Remove".
Remove the prechamber ignition body. Refer to Disassembly and Assembly, "Prechamber Ignition Body - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00572758
Install Tooling (D) and Tooling (B) without the hydraulic cylinder. Move the handle downward to compress the valve spring (1).
Illustration 2 g00572759
Do not remove or install the spring locks with your fingers. If the spring should move, personal injury may result.
Use a magnet to remove the spring locks (2).