GEAR-TRANSFER 8E7567 - Caterpillar

Cylinder Head and Block
The cylinder head assembly has one inlet valve and one exhaust valve for each cylinder. Each valve has a single valve spring and an oil seal. The valve and the valve spring are held in position by a valve spring cap and two collets. The oil seal fits over the top of the valve guide. The valve seat inserts and the valve guides can be replaced.The ports for the inlet and for the exhaust valves are on the left side of the cylinder head.The cylinder block does not have cylinder liners. The cylinder walls are honed.The valve mechanism cover is made from aluminum. The cover contains the following components:
An open breather assembly
An oil filler cap
A seal for the face toward the cylinder head
Holes for three cap nuts
An air inlet manifold on the 3003 engineThe cap nuts are threaded onto studs. The steel studs are threaded into the cylinder head.The gases in the valve cover, which are caused by blowby, pass from the breather assembly to the outside air.Pistons and Connecting Rods
The pistons on 3013, 3014 and 3024 engines have a combustion chamber in the crown of the piston in order to provide an efficient mix of the fuel and the air. Due to the small size of the pistons on 3003 engines, the pistons have a flat crown.The piston pin is off-center in order to reduce the noise level.The pistons have two compression rings and an oil control ring.The correct piston height is important in order to ensure that the piston does not contact the cylinder head. The correct piston height also ensures the efficient combustion of fuel which is necessary in order to conform to requirements for emissions. The piston must not be machined in order to obtain the correct piston height.A piston and connecting rod are matched to each cylinder.One height of piston is available. The piston is marked "Std" on the crown. The underside of the piston is marked "SHIBAURA". This reference mark faces the right side of the engine. Refer to the Systems Operations, Testing and Adjusting Module, "Basic Engine" topic for procedures to measure the piston height.Identification marks on the connecting rod and the connecting rod cap must align. The identification marks face the right side of the engine.The main bearing caps have a chamfered edge on one side. The chamfer faces the front of the engine.Two main bearing caps have notches on the face of the cap that is opposite the side with the chamfer. The bearing cap with the notch toward the outside edge of bearing cap is the number 2 bearing on three cylinder engines. The bearing cap with the notch toward the outside edge of the bearing cap is the number 3 bearing on four cylinder engines.Timing Gear Case and Gears
The timing gear case contains the following components:
The front oil seal for the crankshaft pulley
The bearing for the crankshaft gear
The oil pump
The adjustment screw for setting the maximum fuel position
The adjustment screw for setting the maximum