GEAR-BEVEL 8E7860 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-9392 (1)     Damper Guide Pin     2    
1U-9393 (1) Damper Guide Pin     2    
4C-9426 (1) Damper Guide Pin     2    
B     8T-0914     Flywheel Guide Pin     2    
( 1 ) All of the guide pins are available. The particular guide pin that is required depends on your application.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Illustration 1 g00556435
Remove two bolts (2) that hold vibration damper (1) to the shaft. Install Tooling (A) in the holes.
Remove the remainder of bolts (2). Carefully move vibration damper (1) onto Tooling (A) in order to pass a suitable lifting device through the center of vibration damper (1) .
Attach a suitable lifting device to vibration damper (1). The weight of vibration damper (1) is approximately 188 kg (414 lb). Remove vibration damper (1) .
Illustration 2 g00556436
Remove two of the bolts that hold adapter (3) in place. Install Tooling (B) in the holes.
Remove the remainder of the bolts. Carefully move adapter (3) onto Tooling (B) in order to pass a suitable lifting device through the center of adapter (3) .
Attach a suitable lifting device to adapter (3). The weight of adapter (3) is approximately 30 kg (66 lb). Remove adapter (3) .Note: For information on rebuilding vibration dampers, refer to Reuse and Salvage Guidelines, SEBF8152, "Procedures to Rebuild Vibration Dampers for 3600 Family of Engines".