GEAR (12 teeth) 8G4944 - Caterpillar

1. Loosen nut (1). Remove screw (2) from the bottom of the steering clutch case. 2. Remove four nuts (4) and washers. Remove band assembly (3). 3. Turn band assembly (6) toward rear of tractor. Remove four nuts (4) and washers.4. Remove band assembly (5) and band assembly (6).Install Brake Band And Linings
1. Put two band assemblies (1) and (2) together. Install the four bolts, washers, and nut that hold the band assemblies together. Do not tighten nuts.2. Put the band assemblies in position on the drum of the steering clutches. Tighten the nuts that hold the two band assemblies together. Turn the band assemblies forward until they are under the drum. 3. Put band assembly (3) in position on the drum and the other band assemblies that are in position. Install the four bolts, washers, and nuts. 4. Put screw (4) and nut in the steering clutch case.5. Make an adjustment to the band assemblies and brake pedals. See ADJUST BRAKE BANDS AND LININGS.end by: a) install steering clutchBrake Adjustment
1. Make an adjustment to the brake bands and linings as follows: a) Assemble rod to a length of dimension (B) which is 20.00 to 20.08 in. (508.00 to 510.03 mm).b) Make sure the brake pedals are in a released position. Tighten nut (1) until the band assemblies make contact with the drum of the steering clutches.c) Loosen locknut on screw (2). Turn screw clockwise until it makes contact with the band assemblies.d) Loosen screw (2) one turn. Fasten locknut on screw (2).e) Loosen nut (1) three turns or until dimension (A) is 3 in. (76.2 mm) minimum.