GEAR (80 TEETH) 8H4480 - Caterpillar

Illustration 1 g00952280
Note: Apply 1U-8801 Rust Preventive Oil to all rod ends, all pins, all locknuts, all threads that are adjusting, and all pin holes.Note: Drive on the stamped end of bearings only.Note: Bulkhead nuts must clear seals without damage to seals. (2) Torque for nuts of cable assembly ... 25 7 N m (18 5 lb ft) (7) Torque for nut ... 2.25 0.20 N m (20 2 lb in) (8) Torque for two bolts ... 35 3 N m (25.8 2.2 lb ft)Adjustment Procedure
Put ports (B) in valve group (3) in blocked position (B1) .
Put diverter valve control (1) in down position (A) (front attachment position).
Loosen nut (7). Adjust rod end (4) until pin (5) can be installed through the rod end and lever (6) .
Tighten nut (7) to the correct torque.